Owner's Manual

36
PARTS REQUIRED FOR INSTALLATION OF : DIRECTED DB3
Telematics device HRN-MCAR-01 DB3 HRN-DRS-01 or
HRN-DRS-02
STEP 1. CONFIGURE THE REMOTE STARTER
The Directed XKloader 2 or 3 is required to properly configure the DB3 remote starter to accept the tele-
matic device. When flashing the DB3 remote starter, please ensure to choose the “Smartstart” telematic
protocol.
STEP 2. CONNECT
(1) Connect only when remote starter is not supplying power to telematics device
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
HRN-DRS-02
INSTALLATION, WIRING & PROGRAMMING GUIDE