Owner's Manual

34
PARTS REQUIRED FOR INSTALLATION OF : DIRECTED DBALL 2
Telematics device HRN-MCAR-01 DBALL2 HRN-DRS-01 or
HRN-DRS-02
STEP 1. CONFIGURE THE REMOTE STARTER
The Directed XKloader 2 or 3 is required to properly configure the DBALL2 remote starter to accept the
telematic device. When flashing the DBALL2 remote starter, please ensure to choose the “Smartstart”
telematic protocol.
STEP 2. CONNECT
(1) Connect only when remote starter is not supplying power to telematics device
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
DBALL 2
HRN-DRS-02
INSTALLATION, WIRING & PROGRAMMING GUIDE