Owner's Manual

26
PARTS REQUIRED FOR INSTALLATION OF : COMPUSTAR CM6200
Telematics device HRN-MCAR-01 Compustar CM6200 BLADE-AL (64)
STEP 1. CONFIGURE THE REMOTE STARTER
The ADS Weblink (ADS-USB) is required to properly configure the Compustar remote starter to accept the
telematic device. When flashing the Compustar remote starter, please ensure the remote starter firmware
and BLADE-AL (64) firmwares are updated to the latest firmware available.
STEP 2. CONNECT
(1) Connect only when remote starter is not supplying power to telematics device
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
INSTALLATION, WIRING & PROGRAMMING GUIDE