Owner's Manual

24
PARTS REQUIRED FOR INSTALLATION OF :
COMPUSTAR CM7000 / CM7200 /
POLARSTART PRS-16
Telematics device HRN-MCAR-01
CM7000 / CM7200 / PRS-16
BLADE-AL (64)
STEP 1. CONFIGURE THE REMOTE STARTER
The ADS Weblink (ADS-USB) is required to properly configure the Compustar or Polarstart remote starter
to accept the telematic device. When flashing the Compustar or Polarstart remote starter, please ensure
the remote starter firmware and BLADE-AL (64) firmwares are updated to the latest firmware available.
Then set the Option Group #4 “DroneMobile or Fortin Gray 4pin” to DR-2000 and Flash remote starter.
STEP 2. CONNECT
(1) Connect only when remote starter is not supplying power to telematics device
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery
(RED)
Ground
(BLACK)
Data
(WHITE)
Data
(BLUE)
Alarm(+)
(YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
INSTALLATION, WIRING & PROGRAMMING GUIDE