Owner's Manual

20
PARTS REQUIRED FOR INSTALLATION OF : FLASHLOGIC FLRSBA
Telematics device HRN-MCAR-01 Flashlogic FLRSBA
STEP 1. CONFIGURE THE REMOTE STARTER
The ADS Weblink (ADS-USB) is required to properly configure the Flashlogic FLRSBA remote starter to
accept the telematic device. When flashing the Flashogic FLRSBA remote starter, please ensure to turn ON
the Telematics option from the telematics section and choose “Carlink”.
STEP 2. CONNECT
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
(1) Connect only when remote starter is not supplying power to telematics device
INSTALLATION, WIRING & PROGRAMMING GUIDE