Owner's Manual

16
PARTS REQUIRED FOR INSTALLATION OF : CRIMESTOPPER
Telematics device HRN-MCAR-01 CrimeStopper HRN-LLRS-01
STEP 1. CONFIGURE THE REMOTE STARTER
The CrimeStopper remote starter must be configured to accept the telematics device. When programming
the CrimeStopper remote starter, please ensure to select the option indicated “Smart Phone Baud Rate”.
This option MUST BE SET TO 9600baud.
1- Disconnect the HRN-LLRS-01 white connector from Crimestopper Remote Starter
2- Go in the Crimestopper programming and set Baud rate to 9600.
3- Shut ignition O and Disconnect Power from the Crimestopper RS.
5- Wait 10 seconds. Then Reconnect RS and the HRN-LLRS-01 harness for the MyCar.
STEP 2. CONNECT
(1) Connect only when remote starter is not supplying power to telematics device
Compatible models:
RS-00, RSx-G5, SP402, SP502
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
HRN-LLRS-01
INSTALLATION, WIRING & PROGRAMMING GUIDE