Owner's Manual

12
PARTS REQUIRED FOR INSTALLATION OF : ADS-AL-CA / OL-MDB-ALL
Telematics device HRN-MCAR-01
ADS-AL-CA / OL-MDB-ALL
FLCL6HAR,
OL-HRN-LINKR-ALL
(sold Separately)
STEP 1. CONFIGURE THE REMOTE STARTER
The ADS Weblink (ADS-USB) is required to properly configure the ADS-AL-CA or OL-MDB-ALL remote
starter to accept the MyCar telematics device. When flashing the ADS-AL-CA or OL-MDB-ALL remote start-
er, please ensure to choose the “MyCar” telematics protocol.
STEP 2. CONNECT
(1) Connect only when remote starter is not supplying power to telematics device
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
FLCL6HAR
INSTALLATION, WIRING & PROGRAMMING GUIDE