Owner's Manual

10
PARTS REQUIRED FOR INSTALLATION OF : AKX or OEM
Telematics device HRN-MCAR-01 AKX or OEM
STEP 1. CONFIGURE THE REMOTE STARTER
The ADS Weblink (ADS-USB) is required to properly configure the AKX or OEM remote starter to accept
the telematic device. When flashing the AKX or OEM remote starter, please ensure to choose the “MyCar”
telematics protocol.
STEP 2. CONNECT
(1) Connect only when remote starter is not supplying power to telematics device
3
(+) HORN (PULSE)
OR
(+) SIREN (CONSTANT)
ANALOG INPUT SIGNAL
FOR ALARM DETECTION
(+) 12V BATTERY
(1)
GROUND
(1)
+12V Battery (RED)
Ground (BLACK)
Data (WHITE)
Data (BLUE)
Alarm(+) (YELLOW)
Installation:
Place module 3 inches
(minimum) from any metal surface
Orientation: Horizontal; small door
facing upward (as seen in this diagram)
INSTALLATION, WIRING & PROGRAMMING GUIDE