Owner`s manual
Model S1BTXA
~
AUDIO'~OX
CORPORATION
Transmitter
Programming
Guide
This transmitter is designed for use with your upgrade remote start
unit and is programmed
by
using the remote start's program switch
in
combination with the transmitter button. Although this transmitter can
be
programmed into any
of
the Audiovox remote start and or alarm,
remote start systems, it will offer limited use and should
be
used for
the remote start upgrade only.
To
program this transmitter into your remote start upgrade unit:
1)
Turn the ignition
to
the
on
position
2)
Press and release the programming switch 3 times
3)
Press and hold, for 3 seconds, the button
of
the transmitter you
wish
to
add until the parking light flashes indicating the transmitter
has been learned.
4)
Repeat step 3 for each transmitter up
to
a total
of
4.
Turn the ignition off
to
exit the program mode.
NOTE:
Do
not allow more than
15
seconds
to
lapse between steps
or the program mode will
be
automatically exited and you will have
to
start over.
This device complies with
FCC
Rules Part
15
Operation
is
subiect
to
the following
two
conditions
(1) This device
may
not
cause harmful interference and
(2)
This device
must
accept any interference that may be
received, inclUding interference
lhat
may
cause undesired
operation.
NOTE:The manufacturer
is
not
responsible
for
any radio
or
TV
interference caused
by
unautl10rized modifications
to
this
eqUipment. Such motlifications could void the user's
authority
to
operate the equipment