Installation manual

128-8804b
11 of 16
Page 11
4 PIN IN VEHICLE DATA BUS PORT (DBI Port) (Connector Port)
The 4 pin port located on the side of this module is for proprietary Audiovox data bus interface modules.
These modules are used to access a variety of features in the vehicle which can be as simple as door
trigger inputs, to more complex door locks outputs, or transponder interfaces for remote starting. DO NOT
connect anything to this port other than the Audiovox DBI modules or damage to the Remote Start module
will occur. All installation instructions for the DBI modules will be packaged with the individual component
along with the proper 4 pin wiring harness requires to access the data transmit and receive as well as the
proper voltage levels for the interface.
Wire Dressing:
Always wrap the alarm wires in convoluted tubing, or with a spiral wrap of electrical tape. Secure these
looms along the routing using cable ties. This will ensure that the alarm wires are not damaged by falling
onto hot or sharp moving surfaces in the vehicle.
Operation:
Take a few moments to check off the appropriate option boxes in the owner’s manual and to fully explain
the operation of the system to your customer.