Specifications

Identification lights:
All LED identification lights shall be installed on the vehicle as required by applicable DOT highway
regulations.
• Two (2) tail, stop, turn and back up light assemblies shall be installed at the rear of the body and shall
consist of:
 Clear tail and stop lights with red LEDs – T40-RCFT-1 or equivalent
 Clear turn signals with amber LEDs – T40-ACFT-1 or equivalent
 One (1) clear LED dome light with an on/off switch shall be mounted in the cab ceiling – E13-
W300-1 or equivalent
 One (1) clear/red LED dome light with on/off switch shall be mounted in the cab ceiling – E11-
DS01-1 or equivalent
 Four (4) clear LED ground lights installed under the cab step area in compliance with NFPA #1901
standards
 Two (2) LED step lights with clear lens shall be installed at the rear step of the apparatus wired to
the parking brake circuit – E96-WS00-1 or equivalent
 Six (6) clear LED scene lights shall be installed. Lights shall be operated by an on-cab console
switch. Location: two (2) on each side of body and two (2) at the rear body panel. Fire Research
Corp. or equivalent
 Automatic switches for each scene light shall be installed to activate all scene lights when a
compartment door is opened. The rear scene lights shall activate automatically when the
transmission is in reverse
 Seven (7) compartment’s equipped with T-Systems or equivalent, trip LED lights installed on one
side of door opening. Lights shall be integrated into the roll-up door track with light turning on
with door opening
 Each exterior compartment light shall be automatically controlled by a door activated on/off switch
 A flashing LED light with red lens indicating “Door Open”, or equipment operation light shall be
installed on cab dash
 An automatic electric back-up alarm shall be wired to the back-up light circuit and mounted under
the rear of the apparatus body. Ecco Model SA-907 “Smart Alarm” or equivalent
Warning lights and sirens:
• One (1) electronic siren shall be mounted in the cab. The unit shall have an electronic air horn, wail,
yelp, hi-lo siren and hard wired microphone
• Two (2) 100-watt chrome plated speakers shall be installed and wired to the electronic sire located in
the cab
• Zone A – Upper lightbar
 One (1) Code 3 model #2147 NFPA1 light shall be installed on the cab roof. The LED X2100 series
lightbar shall be 47” l and shall include fourteen (14) red LED single modules. Take down lights
shall be included, wired to wig/wag
• Zone A – Lower front warning lights
 Two (2) Code 3 model #45R LED lights shall be installed in the lower front of the cab. Lights shall
be 3” x 7” and equipped with a red lens
• Zone B and D – Lower cab intersection lights
 Two (2) Code 3 LED lights shall be installed, one (1) on each side of the front bumper. Lights shall
be 2” x 5” and have a red lens