Specifications

Rub rails:
• The sides of the lower body area before and after the wheel well shall have 3” x 1.5” x .250” extruded
aluminum rub rails with end caps or angle corners
• Rub rails shall have red and white DOT type reflective striping
Protective covering:
• The front corners of the apparatus shall have a stainless steel protective covering installed
Door construction:
• Six (6) GRP doors fabricated from fiberglass reinforced polyester shall be provided
• Each GRP door shall have a stainless steel full height, piano style hinge with stainless steel rod
• Stainless steel locking D-ring style handles with slam action single point hardware shall be provided for
each door
• A spring loaded rod guide stay arm style device shall be provided on each door
• Door depth shall align with the body sill depth that has an attaching flange and finishing flange
incorporated in the design
• Low profile side and top seal
• Magnetic door ajar system integrated in the handle and striker retainer block
Rear bumper, tow plates and rear step grating:
• 12” deep Plastisol Composites, or equivalent, step shall be provided and installed at the rear of the
apparatus
• Step shall be equipped with a multi-directional aggressive gripping surface and shall comply with NFPA
#1901 standards
• Rear step and bumper assembly shall have 3” tow plates installed
• Step shall feature a 3 point portable winch connection, one on each side and one at the rear
Handrail – rear step:
• Two (2) stainless steel non-slip handrails, approximately 36” long shall be provided and mounted on
the rear of the of the apparatus, one (1) on each side of the body
Equipment mounting:
• Adjustable 24” deep shelves
• Five (5) adjustable shelves constructed of smooth aluminum plates or composite material shall
be mounted in specified compartments with double bolt shelf brackets
• Each shelf shall have a broken front and rear edge.
• Location of shelving shall be:
♦ Compartment L1
♦ Compartment L2
♦
Compartment L3
♦ Compartment R2
♦ Compartment R3