Specifications

Electrical wiring conduits:
• Surface mounted conduit shall be installed in the body for routing the 12 volt and
the 120/240 volt
wiring
• Material and installation shall conform to applicable NFPA and SAE standards
• Wiring shall be easily accessed through a removable cover
Body painting specifications:
• Exterior and interior of the body as well as associated components requiring painting shall be finished
using the following procedure:
 Composite material shall be sand blasted
 Components are to be chemically cleaned on all surfaces
 All surfaces are to be sanded to proper levels and all sanding residue removed
 Any imperfections or defects shall be filled with premium body filler and sanded smooth
 Top quality glaze applied over body filled areas and sanded
 Components are to be primed with the paint manufacturer’s recommended primer
 Entire primed surface shall be thoroughly sanded and inspected for any imperfections and properly
correct them
 Apparatus body shall be cleaned with a wax and grease remover
 Base coat/clear coats shall be applied following the paint manufacturer’s guidelines
• Body shall be painted using a single color to match the cab primary color
Under body finish:
• Under body shall be finished with black paint, RAL 9005 or equivalent
Interior compartment finish:
• Interior wall, floor and ceiling surfaces of the body compartments shall be finished with Zolatone 20-72
industrial coating
• Silver/gray speckle finish over a Zolatone basecoat primer
Top of body finish:
• Top of body shall be finished with an aggressive non-slip industrial coating
Rear wheel fenderettes:
• Polished stainless steel fenderettes shall be installed at each rear wheel opening and positioned outside
of the wheel well panel to cover the tire area that extends past the body
• Fenderettes shall be secured with threaded fasteners
Fuel fill access:
• Fire shop, or equivalent, stainless steel enclosure with hinged access door shall b installed in the
driver’s side wheel well