Installation manual

128-5850A
11 of 16
Page 11
The AA-RS10CS Remote Car Starter will learn the tach rate of most vehicle's ignition coils, multiple coil packs, and or
single injector. To learn tach;
1. Start with the programming switch in the OFF position.
2. Turn the ignition key to the ON position.
3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
4. Immediately turn the ignition key OFF.
5. Flip the program switch ON, then start the vehicle using the ignition key.
6. When the unit senses the tach signal, the parking lights will begin to flash.
7. Flip the program switch OFF. The parking lights will turn on for 3 seconds to indicate that the tach signal is stored
and the unit is now out of the program mode.
3. Diagnostics:
1. Be sure that programmable feature number #7 is set to the "Diagnostics On" mode.
2. First flip the program switch on, then turn the ignition key to the ON position.
3. The lights will flash, and number of flashes will indicate the reason for shutdown on the last remote start attempt.
The indications are as follows:
1 Flash 10 or 15 Minute Run Timer Expired
2 Flashes Low or No Tach Signal (RPM)
3 Flashes Positive Or Negative Shutdown Wire Activated
4 Flashes Control Switch Moved to Off Position
5 Flashes RF shutdown, Remote signal received, or manual start trigger wire reactivated.
6 Flashes High RPM Signal Received
7 Flashes Tach Has Not Been Programmed
Multi Coil Pack Adaptor: (Optional)
The multi coil pack adaptor, (P/N 136B1400), is designed for use with vehicles having multiple ignition coils where a
single point tach signal is unavailable.
To use the adaptor, the Green/Black wires must connect to the negative side of the ignition coil(s).
1. For vehicles utilizing independent coils per cylinder, connect the three Green/Black leads to alternate coils. To
achieve optimum performance the coil signals must be evenly distributed. This is accomplished by first mapping out
the firing order of the engine in groups of as indicated below. Draw a circle around any of the columns. The Green/
Black wires should be connected to the negative (-) terminal of the respective cylinder number which appears in any
of the circles.
2. For vehicles utilizing 2 cylinder firing per coil pack, connect Green/Black to the tach side of each coil pack. For 8
cylinder, four coil systems, connect to any of the three coils.
3. Connect the Yellow wire to a +12 volt ignition 1 source. This wire will have +12 volts with the ignition in the on and
start position and have 0 volts with the ignition in the off position.
4. Connect the Green wire to the (Green) or (Orange/Green) tach input of the Audiovox remote start unit.
TESTING YOUR INSTALLATION:
WARNING!! The following procedure must be performed after the installation of an Audiovox Remote Start Device. It
is the responsibility of the installing technician to complete these tests. Failure to test the unit in the following manner
may result in personal injury, property damage, or both.