Installation guide

DRIVEN
BY
DICE ELECTRONICS
A-MBR-1501-AVW
R2
Modification
If
vehicle is equipped with factory
satellite
radio and it is to be retained, the harness modification
illustrated
below
is
required.
NOTE:
This modification
will
only work for VW vehicles.
1 Disconnect main radio
harness and
locate
SAT
connector. Remove it
from main harness by
pressing on the
release
tab of the
SAT
connector.
;;[I
~
~~
1111111
SAT
Connector
2
Slide out the inner part of
the
SAT
connector from
plastic
housing.
3
Disassemble
the A-MBR-
1501-AVW
R2
connector
the same way as the
factory
SAT
connector.
LD~
....
4 Remove the
SAT
wires from
the factory connector by
releasing
the pins with a small
screw driver or
ball point pen.
pins 1 ,3, 7
5
Relocate wires to A-MBR-
1501-AVW
R2
connector
keeping the same order and
location.
pins
1
,3,
7
6 Put
plastic
connector covers
back on.
lnsertA-MBR-1501-
AVW
R2
connector to factory
VW main harness.
A-MBR-1501-
AVWR2
connector
7 Connect ground wire to
chassis of radio.