User Guide

ManualsBrandsAudiovox ManualsOther4177

.,.~

Form # 4177

03/98

Summary of content (8 pages)

PAGE 1
~ .,.
PAGE 2
Familiarize yourself with the Installation Instructions and Cruise Control components. A. Wllen disconnecting connectors, hold connector and ress the lock downward while pulling connectors apart. (Figure A) CAUTION: Do Not Pull On Wires ",' ,-~IGURE B B. When connecting mating connectors,push connectorstogether until locking mechanismsare fim11ylocked together. (Figure B) If vehicle is equipped with an Anti-Theft Radio, the radio codemusfbe written down prior to discolmecting battery cable.
PAGE 3
STEP I. HA TTERY DISCONNECT: Ifvehicle is equipped with Anti-Theft Il"eter to vehicle,9wners , , , ,manual for Radio, record security code before disconnecting battery cable. instructions. Raise vehicle hood and remove NEGATIVE battery cable (See FibYilreC). STEP 2 2. Receiver Module Installation: Remove existing Cruise Control Switch, if one exists. Refer tp Ifelpful Hint #2 to when disconnecting 4 pin connector.
PAGE 4
TROUBLE SHOOTING GUIDE REMOTE FOR CRUISE CONTROLLED Equipment ~ WITH SWITCH TRANSMITTER (mounted CONTROL RECEIVER on steering wheel} (mounted under dash) Needed eory o I) Volt/Ohm 2) Jumper Remote meter Wire Controlled Switch Operation The ROSTRA remote controlled cruise switch incorporates the same features and functions as contemporary cruise control switches plus a few enhancements.
PAGE 5
~ , -,..;" '.0'- each function listed with the vehicle and cruise control If results are observed contrary to the indicated desired , fail codes for debugging instructions. ;t.;,~f"r.;c;' , -,c 1 .,A-l T~~T I A-2 INo .FUNCTION Power Ignition , Ignition OFF "OFF' "ON", I 0.
PAGE 6
Mechllnical Tests Veri(v the cruise cable and linkage is properly installed by visually inspecting all related parts of the throttle connection Verify that the cruise control cable is free to operate from obstruction or resistance. Verify that all brackets are secured properly and not damaged. Replace any damaged parts. , c Entering Diagnostics Mode: I. Turn the Cl1lise Control Switch to tile OFF position 2. Turn the ignition switch to the OFF position 1. Turn the ignition switch to the ON position .
PAGE 7
;;"',""f c"- M~, f ~ at the factory or receiver are replaced. In that I I. Install the new transmitter or receiver as described in the manual attached. 2. Use Volt/Ohmmeter to verify the steps you are about to make. I 3. Connect the Volt/Ohmmeter to the Jrd pin from the left (next to Orange wire) on the lO-pin connector of the interface harness. ! 4. 5: The Turn Volt/Ohmmeter the ignition power should on, read without (+5 starting volts ). the engine.