User Guide

ManualsBrandsAudiovox ManualsOther1285849

3 Channel Remote Car Starter

Model AA-RS10CS

Owner’s Manual

FEATURES :

w 2 Three Button Programmable RF Transmitters

w Three Channel Receiver

(capable of accepting 4 transmitters)

w Code Hopping Technology

w ( + ) and ( - ) Keyless Entry Outputs

w On-Board Start Relay

w On-Board Accessory Relay

w On-Board Ignition 1 Relay

w On-Board Ignition 2 Relay

w Ignition 2 Relay Selectable On or Off During Cranking

w On-Board Parking Light Relay

w Ignition 3 / Shock By-Pass / GM VAT Output (relay required)

w Tach Signal Learning Circuit

w Two ( + ) and Two ( - ) Safety Shutdown Circuits

w Alarm By-Pass Output

w Channel 2 Output for Remote Trunk Release (relay required)

w Channel 3 Output to Control Optional Accessories

w Selectable Steady or Flashing Parking Lights for Run Indication

w Selectable 10 or 15 Minute Run Time

w Selectable 1 Second or 3.5 Second Door Lock Output Pulse

Summary of content (4 pages)

PAGE 1
Model AA-RS10CS Owner’s Manual 3 Channel Remote Car Starter FEATURES : w 2 Three Button Programmable RF Transmitters w Three Channel Receiver (capable of accepting 4 transmitters) w Code Hopping Technology w ( + ) and ( - ) Keyless Entry Outputs w On-Board Start Relay w On-Board Accessory Relay w On-Board Ignition 1 Relay w On-Board Ignition 2 Relay w Ignition 2 Relay Selectable On or Off During Cranking w On-Board Parking Light Relay w Ignition 3 / Shock By-Pass / GM VAT Output (relay required) w Tach Sig
PAGE 2
YOUR “CODE HOPPING” TRANSMITTERS The transmitters included with your new remote start system use the most advanced and secure form of radio 1 frequency transmission available on any current automotive 2 3 remote system. Some of today’s sophisticated auto thieves use a device known as a code grabber, which will receive and store the signal from your keychain transmitter, and re-transmit at a later time to disarm your system.
PAGE 3
1. To start the vehicle, press and release the second transmitter button two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 10 or 15 minute run cycle. As a visual indication, the parking lights will flash or remain on depending on the setting by your installation center. 2. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring loaded start position), then step on the brake pedal to disengage the remote starter.
PAGE 4
To activate the optional accessory, press and hold the transmitter's button 2 for 4 seconds. NOTE:The feature that has been added to channel 2 will always be activated using the same transmitter button that remotely starts the vehicle. There is no way to move the channel 2 function to a different transmitter button. ADDITIONAL REMOTE FUNCTION (CHANNEL 3) This system has an additional feature that can be connected to a number of different optional accessories.