6 COMPACT ACC-40 DIGITAL AUDIO 6 DISC COMPACT DISC CHANGER ACC-40 6-DISC CD CHANGER WITH COMMANDER REMOTE CONTROL COMPACT DIGITAL AUDIO O WNER'S MA NUAL
HINTS FOR CORRECT AND SAFE OPERATION This CD Changer is designed to be operated only on 12 volt DC negative ground systems. The unit can not be used on 24 volt or positive ground systems. TEMPERATURE The unit may not operate correctly in extremely hot or cold temperatures. It is equipped with a built-in thermal protection circuit which will stop operation of the unit when the temperature reaches the pre-set level.
HANDLING COMPACT DISCS Dirt, dust, scratches and warpage cause sound skips during playback and a deterioration of sound quality. To take proper care of your discs: COMPACT 1. Use compact discs that have the mark DIGITAL AUDIO 2. Fingerprints and dust should be carefully wiped off the disc's signal surface (glossy side) with a soft cloth. Unlike conventional records, the compact disc has no grooves to collect dust and microscopic debris, so gently wiping with a soft cloth should remove most particles.
USE OF THE CD MAGAZINE LOADING DISCS INTO THE MAGAZINE This CD Changer uses a specially-designed magazine to hold up to 6 compact discs. Insert discs into the magazine with the label side up as shown in Figure 1. As each disc is inserted into the magazine, the release key for that slot will be raised. The discs are numbered from 1 (bottom slot) to 6 (top slot).
LOADING THE MAGAZINE INTO THE CHANGER Completely slide the door on the changer to the right as shown in Figure 3. Making sure the top of the magazine is facing upward, gently insert it into the unit until it clicks into place, as shown in Figure 4. Slide the door of the changer fully closed and the unit is ready for operation. Fig. 3 6 CO M PA CT Door REMOVING THE MAGAZINE FROM THE CHANGER To remove the magazine, slide open the door on the changer and press the eject button as shown in Figure 5. Fig.
OPERATING INSTRUCTIONS This CD Changer is designed to operate through the FM stereo section of your existing car radio. The adjustment of volume, balance, tone and other audio functions is made by using the controls on the car stereo, whereas control of disc play is accomplished by the CD Changer Commander wired control, which can be mounted at a convenient place on the dashboard. The output signal from the CD changer can be either 89.1 or 88.7 MHz (set by the installer) on the FM band.
1 LIQUID CRYSTAL DISPLAY PANEL 5 TRACK SELECT BUTTONS (T-UP/T-DN) 2 PLAY/PAUSE SELECTOR ( 6 TRACK SEARCH BUTTON The Liquid Crystal Display (LCD) panel will illuminate when the CD changer is operating and will display the disc and track numbers as well as various function symbols as described in the following sections. II ) Pressing this button turns on the CD changer, illuminates the LCD panel and begins play of disc #1 if a new CD magazine has been loaded into the changer.
TRACK / DISC REPEAT (RPT) When the RPT button is pressed, the RPT indication will appear on the display and play of the selected track will be continually repeated until the Track Repeat mode is canceled by pressing the RPT button again or by activating the Random or Scan functions.
ERROR CODES If a problem should develop while operating the CD changer, the following error codes may appear on the display panel. ER-1: Indicates that there is no magazine loaded in the CD Changer. ER-2, Indicates the disc is not loading or ejecting properly. Try re-loading or pressing the Eject button. Check the 3 & 4: condition of the disc in use or try another disc. ER-5: Not user serviceable, contact an approved warranty station near you for further assistance..
TROUBLESHOOTING An error made in operation or during installation of this product may be mistaken for a system malfunction. Please perform the checks described below before contacting your dealer or service facility. Symptom Remedy Blown fuse Check fuses in vehicle fuse box and changer system. Replace as necessary with fuse of same type and rating as original. If fuse blows again, consult with service facility. Incorrect connection Check all wiring and correct as necessary.
12 MONTH LIMITED WARRANTY AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.
© 2000 Audiovox Corp., 150 Marcus Blvd., Hauppauge, N.Y.
