Specifications

ee--mmaaiill::
[e-mail]
vvooiiccee::
360.854.9559
ffaaxx::
360.854.9479
14
SS 4.2 Installation and Operation Manual
INSTALLATION
*uCSAtttt - Set silence sensor time delay to tttt seconds (0002 – 9999),
0000 = OFF
*uCSBtttt - Set silence sensor restore delay to tttt seconds (0002 – 9999),
0000 = OFF
*uCSDttt - Ignore, send OK
*uCST - Ignore, send OK
*uCSVttt - Ignore, send OK
Relay and Open Collector Commands:
*uORrF - Unlatch output relay “r”
*uORrL - Latch output relay “r”
*uORrP - Pulse output relay “r”
*uOOoF - Unlatch open collector “o” (Only works in NON-Remote mode
*uOOoL - Latch open collector “o” (Only works in NON-Remote mode
*uOOoP - Pulse open collector “o” (Only works in NON-Remote mode
Audio Switch Control Commands:
*uiio - Apply input “ii” to output “o”
*uiiA - Apply input “ii” to ALL outputs
*uiiEott - Start overlap – Apply input ii to output o. After tt tenths of a sec-
ond, remove all other inputs from output o.
NOTE: Only one at a time can be pending per output. Max time 9.9 seconds
*uE - End overlap if in overlap mode. This applies to all outputs that have
changed since the last “end overlap” command was issued.
*uB,a,a,a,a - Sets inputs, ignoring mode: NOTE: Input commands MUST be in
CAPS.
- A = All “OUTPUTS” OFF
- B = Output 1
- C = Output 2
- D = Outputs 1 + 2
Example: *0B,B, C, D, A (Input 1 to output 1, Input 2 to output 2, Input 3 to
both outputs, input 4 is OFF.
*uii3 - For input “ii”, set output 1 on without affecting any other audio sta-
tus
*uii4 - For input “ii”, set output 2 on without affecting any other audio sta-
tus
*uii5 - For input “ii”, set output 1 off without affecting any other audio sta-
tus
*uii6 - For input “ii”, set output 2 off without affecting any other audio status
*uiiMA - Mute input “ii” for all outputs
*uiiMo - Mute input “ii” for output “o”
*uMo - Mute output “o”
*uMA - Mute all outputs