User`s manual

Chapter 3 Function
3-50
3
 Buffering Rate
The buffering rate can be set for accumulating the measurement data for a
long duration by taking adequate sampling cycle intervals.
Select from 1 (all measurement data), 1/2, 1/4, etc. to 1/65535.
The buffering rate is set to “1/10” by default.
If 1/4 is selected for example, measurement data will be accumulated once every
four sampling cycles.
All measurement data can be accumulated. If measurement data deviation is
small at each sampling cycle, however, the duration of data accumulation longe
r
than that performed per sampling cycle can be set with an appropriate
accumulation interval of measurement data specified. This is useful for the
effective use of memory since the accumulated amount of data items is limited.
 Accumulated Amount
This function sets the accumulated amount of measurement data items.
This function sets the accumulated amount of measurement data items in a range of
1 to 3000.
The accumulated amount is set to “3000” by default.
Accumulation will not start unless the “trigger point” settings for the “accumulated
amount” of data items are correct.