User`s manual

Chapter 3 Function
3-48
3
 Data Buffering Operation
Data buffering procedure
1
Make necessary settings for
buffering.
• Buffering mode
• Buffering rate
• Accumulation amount
• Trigger conditions
• Trigger delay • Trigger point
2
Transmit the start command and start
buffering.
• Buffering operation start
3
Start data accumulation.
Start accumulation to the built-in
memory of the sensor head.
* The start of accumulation varies
with each buffering mode.
4
Wait until accumulation is completed.
The accumulation status can be
checked by "Status Readout."
• Status Readout
5
Stop buffering by transmitting the
stop command.
• Buffering operation stop
6
Read out the accumulated data result.
• Last data point
• Data readout (normal)
• Data readout (high speed)
No settings related to buffering can be changed while the system is in buffering operation.
Change the settings after stopping the buffering operation of the system.
(1) Send settings
(2) Buffering start
(4) Status check
(5) Buffering stop
(6) Accumulated
data readout
HL-G1 PC (Host device)
(3) Accumulation
start
Yes
No
Is accumulation
completed?