User`s manual

Chapter 3 Function

3-46

 Reset

The function resets the measurement value.

At the time of making a peak measurement, valley measurement, or peak-to-peak

measurement with external multi input (MI), the measurement value kept on hold

at the desired timing can be reset.

Input a specified pulse width as multi input.

The pulse width can be input into the high-function type through a communications

command.

For details,

refer to "2-4 Timing Chart".

All judgment outputs will be turned OFF when

“

Reset

”

is executed. This

function can be applied to judge each measurement object for peak, valley, o

peak-to-peak measurements.

•

If “Reset” is executed, the system will be in a data unfixed status, analog output

will be set to a preset fix value (21.6 [mA] and +11.000 [V]), and all the

judgment outputs will be OFF.

•

If Reset ON is executed by a communications command, the memory contents

will be cleared to zero after Reset is executed.

•

The sensor head does not save setting changes made over the multi-input line.

Save the settings over the multi-input line, through the panel, with the

communications command, or with the operation of the console if the settings

need to be maintained after the system is turned OFF.

● Setting Procedure

Press the [UP]/[ENTER] keys together

while in Run mode.

Reset will be executed.