User`s manual

Chapter 4 Communications Control
4-22
4
 Read Commands
Item Command Data Description Format
Measurement
Va lu e Re a d
RMD -
-9500000 to
+9500000
-950.0000 to
+950.0000[mm]
FORMAT
2
Read Received
Light Intensity
RID -
+00000 to
+04095
+00000 to +04095
+00000 Alarm OFF
Alarm status
ROA -
+00001 Measurement Alarm ON
+00000 OUT1 OFF
OUT1 Terminal
Read
RZA -
+00001 OUT1 ON
+00000 OUT2 OFF
OUT2 Terminal
Read
RZB -
+00001 OUT2 ON
+00000 OUT3 OFF
OUT3 Terminal
Read
RZC -
+00001 OUT3 ON
FORMAT
1
Read Command
All Outputs
Read
RMB -
-
Mesured value/Received
light intensity
/OUT1/OUT2/OUT3/AL
FORMAT
3
*1. The data section consists of 5 digits (zero suppress is omitted) indicated in
decimal.
 Buffering Commands
Item Command Data Description Format
+00000 Continuous
Buffering Mode
RBD WBD
+00001 Trigger
Buffering Rate
RBR WBR
+00001 to
+65535
+00001 to +65535
Accumulated Amount
RBC WBC
+00001 to
+03000
+00001 to +03000
Trigger Point
RTP WTP
+00001 to
+03000
+00001 to +
accumulated amount
Trigger Delay
RTL WTL
+00001 to
+65536
+00000 to +65535
+00000 At timing input ON
+00001
At or higher than
threshold
+00002 Lower than threshold
+00003 At an alarm occurred
RTR WTR
+00004 At an alarm released
FORMAT
1
Buffering Command
Trigger
Conditions
Threshold
RBL WBL
-9500000 to
+9500000
-950.0000 to
+950.0000[mm]
FORMAT
2