Specifications

4.3 ANECHOIC FREQUENCY RESPONSE OF A LOUDSPEAKER SYSTEM
Up to now what was in the CLIO box was sufficient. To proceed now you have to
connect your own audio power amplifier via an an RCA cable. The amplifier should
possess a flat Frequency Response and a low output impedance. Check that the
CLIO generator is turned OFF and that the amplifier is turned OFF. Connect
CLIO's Output to the amplifier input and the amplifier's output to the speaker you
are measuring. Refer both to the above picture and the schematic below
Note that the polarity of the cable from the amp to the loudspeaker is inverted. This
42 4 ENJOY CLIO POCKET CLIO POCKET - SURVIVAL GUIDE