Specifications

Obviously yours should be different with a similar shape. You will have to adjust the
Y scale either manually or with the AutoScale Button. Why we changed Units to
Ohm should be obvious. Increasing the Size of the Measurement and relative FFT
brings enhanced low Frequency resolution. This is advisable measuring woofers and
midranges. The default output level of 1.000V is fine in most cases, but can be
increased with high impedance devices. Input level should be set to the maximum
gain before overload occurs to. This maximize SN ratio. For 1.000V output 0dBV is
a good starting point.
Before dealing with how to calculate T&S Parameters, which is a post-processing of
Impedance Measurements, let’s be sure that we have everything set by measuring
Capacitors and Inductors. Just disconnect the Loudspeaker and replace it with
either of the two.
36 4 ENJOY CLIO POCKET CLIO POCKET - SURVIVAL GUIDE