Operating instructions

- Commissioning -

T-NET functions

Your telephone supports the most important DEUTSCHE TELEKOM added value

services (e.g. brokering, call waiting, three-way conferencing, etc.). Please

contact DEUTSCHE TELEKOM to gain access to these functions (some of which are

subject to charge). When using T-NET functions, move the slide switch on the

underside to the “300ms” position.

3.6 Fitting the desk support

If you intend to use your telephone on a desk, then the desk support supplied

must be fitted. To do this, turn the telephone over. Now insert the two upper

hooks into the openings provided and push the desk support firmly home.

If you ever need to remove the support, press gently on the middle clips on the

upper edge and then pull the desk support off.

In the receiver rest there is a small hanging device, which is used when the

telephone is wall mounted. This hanging device is not required when the

telephone is used on a desk, as it impedes the lifting of the receiver. Using a small

screwdriver, turn this hanging device until the screw is completely flush and its

upper end does not protrude at all.

3.7 Wall mounting

Your telephone is also suitable for wall mounting. Use two screws for fixing. Drill

two holes horizontally side by side, 70 mm apart, and leave the screws protruding

from the wall by 5mm. Now place the telephone over the screws and push it

slightly downwards.

There is a small hanging device in the receiver rest to prevent the receiver from

falling when it is placed on the rest with the telephone mounted on the wall. Using

a small screwdriver, turn this hanging device until a small hook appears at the

upper end.

If you are using the telephone fitted to the wall, you can hang the receiver on the

telephone without hanging up. You will find a small hook for this purpose at the

upper end of the receiver rest.