Operation Manual

Putting the Telephone into Operation

Connecting the charging station

Connect the charging station as

illustrated in the diagram.

For safety reasons, only use the

power adapter plug supplied.

Inserting the rechargeable batteries

Insert the battery pack in the open battery

compartment and plug the connector in the

connection socket. Lay the cable in the grey

area beside the batteries. When replacing the

batteries, only use ones of the same type.

Close the battery compartment.

Charging the batteries

Before the handset is used for the first time, insert it in the base station / charging

station for at least 14 hours.

When the handset is inserted in the base/charging station properly, you will hear a confir-

mation signal and the charge control lamp lights up. The handset warms up during the

charging process. This is normal and does not represent a risk. Do not charge the hand-

set with charging units from other manufacturers. The current battery charge status is

indicated in the display:

Full Half empty Low Empty

Setting the time on the handset

The time and date are set via the menu. Refer to Page 42 for the sequence of option

selections.

Private branch exchanges

The information on Page 40 explains how to install your telephone in a private branch

exchange.

Only applies to telephone sets with at least two handsets;  Checking the contents

of the package" on Page 31.

Mains power outlet