FF893 Cordless telephone with digital answering system This equipment is not designed for making emergency telephone calls when the power fails. Alternative arrangements should be made for access to the emergency services. User guide Downloaded from: http://www.guardianalarms.
AUDIOLINE FF893 SAFETY INFORMATION IMPORTANT INFORMATION Use only AUDIOLINE approved cadmium-free NiMH rechargeable battery pack within the handset. Never use other packs. Your replacement packs are available from DORO Australia and many leading retailers. Do not use any power supply except the one provided (Approval No. N/12462). Connection of any other adaptor could compromise the compliance with Australian/New Zealand standards.
CONTENTS AUDIOLINE FF893 LIST OF CONTENTS Handset functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Base Unit functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installation Positioning the base unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Base installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
AUDIOLINE FF893 INSTALLATION HANDSET FUNCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 2 Antenna Earpiece Talk LED Talk Button Keypad Memory button Recall button Pause button 9. 10. 11. 12. 13. 14.
INSTALLATION AUDIOLINE FF893 BASE UNIT FUNCTIONS 1. L d speaker 2. Speaker Volume control 3. Answer ON/Off, Message LED 4. Answering machine function keys 5. Page button 6. Power / Low Battery LED ou 7. 8. 9. 10. 11. 12. 13.
AUDIOLINE FF893 INSTALLATION POSITIONING THE BASE UNIT It is essential for best performance of the telephone system that the base unit be positioned properly in your home or office. Place the base unit close to a telephone network socket and a 230/240 volt mains outlet. If the range of operation between the handset and the base unit is not satisfactory, try repositioning the base unit, but: # Do not position the unit in direct sunlight, damp or high humidity locations.
INSTALLATION AUDIOLINE FF893 HANDSET BATTERY INSTALLATION To install or change the battery do the following: # Remove the battery cover by applying gentle pressure to the rear of the handset and slide downwards. # Insert the battery (supplied), observing correct polarity (ensure red wire is on left hand side) and replace the battery cover. FIT the aerial to the handset. # Place handset onto base unit (face up or down) and charge for 14 hours. The telephone should not be used during this time.
AUDIOLINE FF893 TELEPHONE MAKING A CALL # Press the [TALK] button. # Dial the telephone number. # To terminate the call, press the [TALK] button or replace the handset on the base unit. RECEIVING A CALL When an external call is received, the base unit will ring first and the in-use LED will flash. # If the handset is on the base unit, you will be connected automatically with your caller as soon as the handset is lifted.
TELEPHONE AUDIOLINE FF893 RANGE WARNING If you are on a call using the handset and move out of range of the base unit, the sound quality in the handset earpiece will de-grade and the out of range alarm will be heard. You should move back into range of the base unit to regain good sound quality. LOW BATTERY INDICATOR When the handset battery is low, the “Talk” LED will flash and an alert tone will sound every 30 seconds.
AUDIOLINE FF893 TELEPHONE MEMORY NUMBERS Nine of your most frequently used telephone numbers can be stored in the memory. Storing of numbers should be done via the handset. STORING MEMORY NUMBERS To store numbers in memory do the following: # Press and release the [MEMORY] button, the Talk LED will flash. # Press and release the location button (1 - 9) on the keypad where you wish to store the number. # Enter the number you wish to store (max 20 digits).
TELEPHONE AUDIOLINE FF893 CALL WAITING Your telephone lets you take advantage of the Call Waiting service supplied by Telstra (Australia). With the call waiting service activated do the following: # When a call comes in while you are on the phone, you will hear the Call Waiting beeps. # Press the [CALL WAITING] button on the handset. The first caller is put on hold and you can talk to the second caller. # To toggle between callers, simply press the [CALL WAITING] button again.
AUDIOLINE FF893 ANSWERING SYSTEM SETTING THE CLOCK It is necessary to set the internal clock in the system to the current time. To set the time do the following: # Press the [TIME/SET/SKIP] button until you hear “Sunday”. # Press [TIME/SET/SKIP] to forward to the day required. # Press the [STOP] button to confirm the day selected (you will then hear 12.00am). # Press the [TIME/SET/SKIP] button to forward to the required hour.
ANSWERING SYSTEM AUDIOLINE FF893 THE OUTGOING MESSAGES (OGM) OGM1 - PRE-RECORDED MESSAGE # Your answering system is pre-recorded with the following message to your caller: ‘Please leave your message after the tone’ # To listen to this message, press and release the [OGM1] button. NOTE: Once the OGM1 is played, the system will set to “ANSWER ON”. OGM1 - YOUR OWN RECORDING You can record your own message, it will replace the pre-recorded message. # Press and hold the [OGM1] button until you hear a beep.
MESSAGE PLAYBACK # When a message has been received the MESSAGE LED on the base will flash quickly. # Press the [PLAY/PAUSE] button to play the messages. # When all the messages are played you will hear a long tone. # If there are no messages when you press the [PLAY/PAUSE] button, you will hear 3 beeps (error tone). NOTE: Your answering system can store messages up to a total of 14 minutes recording time. OPTIONS DURING MESSAGE PLAYBACK # Press STOP to stop. # Press SKIP to forward to the next message.
ANSWERING SYSTEM AUDIOLINE FF893 MEMO RECORDING Instead of writing notes on paper you can inform your family/office by recording a memo. The family or office staff can access the memo to get your message. To record a memo message do the following. # Press and hold the [MEMO] button until a beep is heard. # Record your memo. # When you have finished, release the [MEMO] button. 2-WAY RECORDING # Press and hold the [2 WAY] button until you hear a tone.
AUDIOLINE FF893 REMOTE ACCESS REMOTE ACCESS Your FF893 allows you to control the system from an outside phone. ENTERING REMOTE CONTROL To enter the remote control mode, do the following: # Call your phone from a tone dialling telephone. # When you hear the greeting, enter the 3-digit security code after the beep (located on the bottom of the base unit). This must be done within 20 seconds. # Enter the control codes (from the table below) after the second beep.
ANSWERING SYSTEM AUDIOLINE FF893 REMOTE TURN ON THE SYSTEM If you forget to switch your system on before leaving home, simply do the following: # Call your telephone number, the FF893 will answer after 12 rings. # Enter your 3-digit security code after the beep (you have 20 seconds). # Enter required command/s after the second beep. NOTE: If no command is entered within 20 seconds of entering the security code the system will drop the line.
AUDIOLINE FF893 TROUBLESHOOTING TROUBLESHOOTING All cordless telephones are radio transmitters and receivers and as such are subject to interference from a wide range of sources. Re-siting of the base unit can improve reception substantially. Electronic equipment like TV’s, computers, etc., can emit strong electro magnetic fields which can affect the radio signals.
OTHERS AUDIOILNE FF893 THE HANDSET WILL NOT CONNECT WITH AN INCOMING CALL WHEN THE BASE UNIT RINGS P Because this is a cordless telephone, the ringing signal has to be transmitted to the handset which can take a few seconds. It is important that a call is not picked-up on the handset until the handset rings. THE HANDSET DOES NOT RING P Is the ringer set to Off? (see page 7). MEMORY DIALLING DOES NOT WORK P Store a new number and try again (see page 8).
AUDIOLINE FF893 OTHERS REN (RN for New Zealand) The REN (Ringer Equivalance Number) or RN is of significance only if you wish to connect more than 1 telephone to your telephone line. Your telephone line has a maximum REN capacity of 3 (RN of 5). Your Audioline FF893 has a REN of 1 (RN of 1), thus it is feasible to connect 2 (4) more telephones of a value of 1 to your system.
WALL MOUNTING AUDIOLINE FF893 WALL BRACKET INSTALLATION GUIDE 1. Put the telephone mounting bracket template on part of the wall which is free from obstructions and wiring. 2. Using a pencil, mark the two required fixings. Drill holes if required. 3. Run the cable from the phone through the wall mounting bracket. 4. Screw the mounting bracket to the wall using screws. It may be necessary to use plastic wall plugs to secure firmly. (Screws and plastic wall plugs not supplied.) 5.
AUDIOLINE FF893 OTHERS NOTES FOR OPERATION IN NEW ZEALAND ALL PRODUCTS The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with the minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.
21
