Operation Manual

- Setting up -
42
3 Setting up
3.1 Safety information
NOTE: Before setting up, it is essential that you read the Safety Information at the
beginning of this operating manual.
3.2 Check contents of pack
The following items are supplied:
one base station one mains cable
one handset two standard batteries
one telephone connecting cable one instruction manual
3.3 Connecting the base station
Position the telephone near to your telephone connection socket and to a mains socket.
1. Insert the plug of the power supply into the socket on the backside of the base station
and plug the power supply into a properly installed 230 V mains socket. The plug-in
power supply for the base station must always be connected. For safety reasons, use
only the plug-in mains power supply provided.
2. Connect the telephone cable supplied to the telephone socket and the telephone jack
on the backside of the base station. Use only the new telephone cable provided.
3.4 Fitting standard batteries
To fit the standard rechargeable batteries supplied into the handset, press
on the upper edge of the battery compartment and slide it downwards. Now
insert the batteries taking care to ensure that the polarity is correct. Close
the battery compartment cover.
Important note: Place the handset in the base station with the display to the front for at
least 16 hours. The telephone may malfunction if the batteries are not properly charged.
The charging light on the base station will come on.
+
AAA
+
AAA