Operation Manual

- Multiple handsets -

9.3.4 Logging off handsets

A handset can only be logged off using another handset that is still logged-on. It is therefore

not possible to carry out the logging-off procedure using the handset that is to be logged off.

1. Press the button on the handset.

2. Select the SETUP menu with and and confirm with .

3. Select the DEL HANDSET function with and and confirm with .

4. Now enter the PIN code of the base station (factory setting 0 0 0 0) and confirm with

the button.

5. Now select the number 1 or 2 of the handset to be logged off and confirm with the

button. You can abort the process by pressing the button. If the logging-off is

successful, after a few seconds you will hear a signal tone. The handset is now logged

off and can no longer be used for external and internal calls.

9.4 Additional base stations

You can increase the range of the handsets by using several base stations. In order to

make use of this effect, all base stations must be connected to a telephone socket.

Depending upon the application, you can allocate the same telephone number to each base

station or you can give the base stations different numbers. Make sure that the ranges of all

base stations overlap. Each handset must be logging on to each basis station. Please test

the range of the handsets before putting a new base station into operation.

If a handset is logged on to the base station and if the automatic base station selection is

activated (further information in this chapter), the handset is always forwarded automatically

to the nearest base station. Current calls cannot be transferred from one base station to

another.

Selecting a base station

1. Press the button on the handset.

2. Select the REGISTER menu with and and confirm with .

3. Select the SELECT BASE menu with and and confirm with .

4. The display will now show all base stations that the handset is already logged on to.

The number of the currently active base station will flash. Select the required base

station to which the handset is to be switched by means of the number pad.

Or change to the AUTO setting with the and buttons. With this setting, the

handset changes automatically to the nearest base station when the connection to the

current base station becomes too weak.

5. Confirm with the button.