Operation Manual

- Operation -

4.5 Dialling stored numbers from the phone book

After you have stored a few phone numbers, you can call these up very quickly and easily.

How you store numbers into the directory, is described in Chapter 5.1.

1. Press the phone book button . The display will now show the first number stored in

alphabetical order.

2. You can now select all of the stored numbers with the and buttons.

To choose a phone number directly alphabetically, press the appropriate letter.

3. Now press the call button and the telephone number displayed will be

automatically dialled.

4.6 Call duration display

The call duration in minutes and seconds is shown in the display during a call. Fifteen

seconds after dialling, the display will switch from showing the number dialled to showing

the duration of the call. The call duration will still be retained in the display for a few seconds

after the call has been ended.

4.7 Switching the handset on and off

You can switch off the handset by pressing and holding the button. If the handset is

switched off, no battery power will be used. It will not be possible to receive calls.

Press the

button once to switch the handset on again. The display will show the

message BASE 1 and the handset will switch on again after a short time. The handset will

switch itself on automatically as soon as you replace it on the base station.

4.8 Range information

The range of the handset is ca. 50 metres in closed rooms and ca. 300 metres outdoors.

When there is a good contact with the base station, the

symbol will come on in the

display.

If you are too far away from the base station, the

symbol will flash and you will hear

warning tones. In this case, move nearer to the base station once more, as otherwise the

call will be interrupted. These warning tones can be switched off as described in Chapter

8.8.

4.9 Muting the microphone in the handset

You can turn off the handset microphone during a call by using the button. It is thus

possible to speak without the other person hearing you. The loudspeaker in the handset

remains switched on and you can continue to hear the other person.

1. Press the button once during a call. The message MUTE will appear in the

display.

2. To switch the microphone on again, press the button once more. The MUTE

message will go off and you can continue the call as normal.