Operation Manual

− Telephone Answering Machine −
109
Button Functions during playback of
Options menu
Functions during playback of a
message
8 Switch the telephone answering
machine on/off
9 Record outgoing message
0 twice Delete all old messages
0 Delete current message
# Play Options menu again
5 and # Play back Options menu
On−hook End remote access
17.10.5 Remote activation of the answering machine
The remote access feature enables the answering machine to be switched on via any
telephone which uses the tone dialling method.
 Dial your own phone number
Button *,  Wait 10 rings, press after the acoustic signal and
enter the PIN code
Note: If an incorrect entry is made, the outgoing message is repeated. If the
security code is entered incorrectly three times, the line is automatically
disconnected.
Button 8 Switch the answering machine on/off
Note: Other functions can be executed via the remote access system within the
following 8 seconds. Refer to the table in Chapter 17.10.4.
Replace receiver End remote access
17.10.6 Free of charge pre−remote access
The free of charge pre−remote access function can be used to determine whether
messages have been left on your answering machine without accruing any telephone
charges.
To do this, set the Delay taking calls" function to toll−saver". Refer to Chapter 17.5.3.
When you subsequently call the answering machine while underway, the answering
machine responds as follows:
S If your call is taken after 2 rings, there are new messages on the answering
machine.
S If no new messages have been recorded, the call is not taken after 2 rings.
Replace the receiver immediately because the call will be taken after 4
rings. No telephone charges are necessary because no connection has
been made.