Operation Manual

- Commissioning -
38
3 Commissioning
3.1 Safety information
NOTE! Before commissioning, it is essential that you read the safety information at
the beginning of this manual.
3.2 Check contents of pack
The following items are supplied:
one base station one charger
two handsets with belt clips two accupacks
one telephone connecting cable one power supply for the base station
one Operating Manual one power supply for the charger
3.3 Connecting the base station
Position the base station near to your telephone socket and a mains socket. Your
telephone works using the TTD dialling system (Touch Tone Dialling).
1. Insert the power supply plug into the
socket on the rear side of the
base station and insert the plug-in mains power supply into a properly
installed 230V mains socket. The base station plug-in mains power supply
must be connected at all times. For safety reasons, use only the plug-in
mains power supply supplied.
2. Connect the telephone cable supplied to the telephone socket and the
phone jack
on the rear side of the base station. Use only the new
telephone cable supplied.
3.4 Connecting the charger
Set up the charger for the second handset within reach of a electricity supply
socket. Insert the connector on the lead from the transformer plug in the socket on
the rear side of the charger and insert the transformer plug in a 230V supply
socket installed in accordance with regulations. For safety reasons, use only the
transformer plug supplied.