Operation Manual

- Operation -
70
4.3 Making calls
1. Enter the required telephone number with a maximum of 18 digits using the
number pad. The numbers pressed are shown in the display. If more than
16 digits are pressed, the
indicator on the left-hand edge of the display will
appear and the last 16 digits will be shown.
2. Press the call button and the required connection will be made.
The call duration in minutes and seconds is shown in the display during a call.
Ten seconds after dialling, the display will switch from showing the number
dialled to showing the duration of the call. The call duration will still be
retained in the display for a few seconds after the call has been ended.
3. To end the call, press the call button or replace the handset on the base
station.
Note: If you have entered a number incorrectly, you can delete the number by
repeatedly pressing the button. The number is completely deleted by pressing
the button for a long time.
You can also get a dialling tone by first pressing the call button
. On entering the
digits of your required phone number, your telephone will dial the number directly.
With this method of making a call, it is not possible to correct individual digits in the
number in the manner described above.
Note: If another handset is already using the external line, the message EXT will
appear on all handsets. In this case, it is not possible to make a further external call.
4.4 Making an internal call
When you have connected multiple handsets to a base station, you will be able to
make internal calls. To do this, press the
button and then the number of the
required handset. The display shows the internal call number 1 or 2.
The call is accepted with the call button
on the handset called.
If an external call comes in while you are making an internal call, you will hear short
signal tones and the message EXT will flash in the display. To take the external call,
end the internal call by means of the call button
and accept the external call with
the call button
.