Owner's Manual
How
to
Pair
Multiple
W3
Receivers may be paired
with
one Sender,
allowing the Sender
to
simultaneously broadcast audio
to
all
Receivers,
with no degradation
of
the audio signal.
Pairing a Sender and Receiver:
1)
Press
and hold the pair
button
on the
W3
Sender for
about
5 seconds until the status indicator blinks rapidly.
W3
Sender and Receiver
sets
packaged together are
already paired,
so
if
you're only using one setthey
2) Now go
to
the
Receiver,
then press and release the pair
button
on
the
W3
Receiver.
will remember each other and
no
further configuration
is
needed.
3) Both Sender and Receiver status indicators will
turn
solid,
indicating
they
are paired.
The following procedure explains
how
to
add additional
W3
Receivers
to
a Sender
or
to
pair a Receiver
to
another
Sender.
4) Repeat these steps
to
pair
with
additional Receivers.
Once a Sender and Receiver are paired, they will remember
each other.
Troubleshooting
Here are a few tips
to
try
if
your
W3
is
not
performing
as
it
should.
Sender and/or Receiver status
indicators are
not
lit:
Sender and Receiver status
indicators are
both
blinking:
Sender and Receiver status
indicators are
both
solidly lit,
but
no audio:
Support
•
Check
that the Sender and
Receiver
are
connected
to
power (from a
USB
port
and/
or
power adapter).
•
If
using a computer, verify
that
the
Sender (and
not
the
Receiver)
is
connected
to
the computer's
USB
port.
•
Repeat
the
Sender/Receiver
pairing
process
(see''Howto
Pair''
above).
• Check
that
the Sender
is
connected
to
the desired audio source and the Receiver's
output
is
connected
to
the
correct audio input.
• Check
that
all cables are properly connected. Unplug and reconnect each
to
verify.
• Check
that
your
desired
audio
output
source
(into
the
Sender)
is
present.
• Check
that
the
Receiver's
output
is
connected
to
the
device which
is
powered on
and working.
•
If
connected
to
a computer, verify
that
USB
Audio Device "Audioengine
W3"
is
selected in your system
(see
"Configurations"
#1
).
• If connected
to
a computer and using iTunes, verify
that
"Computer"
is
selected in
the lower right corner
of
iTunes.
•
If
using a computer, check
that
the
Sender (not the Receiver)
is
connected
to
the computer's
USB
port.
If
you have any questions
or
feel you may need service, contact
us
via email: support@audioengineusa.com
or
call toll-free in
the
United States: {877)
853-4447
Technical Specifications
Item
Condition Specification
Item
Output
level
mV 680 Signal-
Noise
Ratio
Frequency
Response
100
Hz
dB
o
~----+--------+--------~
(l
kHz=OdB)
10kHz
dB
0
THO
%
0.1
Effective
Distance
(typical)