Instruction Manual

Step 3 – Connecting the Power Supply
Be sure that the volume/power switch on the front panel is in the OFF
position by rotating it counterclockwise until you hear a click.
Connect the cable with the round end from the power supply to the N22 rear
panel power connector. Note that this connector is “keyed” so line up the
arrow on the cable end with the arrow on the rear panel. Please do not use
excessive force on the connector and use only the power supply provided
with the amplier.
Connect the AC power cable from the power supply to a power outlet and
verify that the indicator light on the power supply is illuminated. We
recommend using a high-quality surge suppressor and/or AC line lter on all
electronics equipment.
Step 4 – Connecting Audio Sources
Using the appropriate audio cable (3.5" mini-jack and/or RCA cable),
connect your audio source (computer, iPod, etc.) to the N22 audio inputs.
One of each cable type is included with your amplier.
Step 5 – Operation
Turn on the N22 volume/power knob and set the volume control to an initial
setting of about 3 o’clock. The front panel power indicator will be
illuminated.
Turn on your audio input source and adjust the volume to your desired
listening level.
Note that both audio inputs on the N22 are active so two audio sources may
be connected to the amplier at the same time without the need for an
input switch. We recommend using the volume control on each audio
source to adjust the overall system volume.
5
6
audioengine N22 setup guide audioengine N22 setup guide


Using Bare Wire
 Use your thumb and nger to unscrew the
binding post connectors on the back of each
speaker.
 Insert each speaker wire into the holes on the
side of the binding post connectors, observing
proper polarity.
 Retighten the binding posts with your ngers.
 The stripped portion of the wire should be
secured rmly in each connector.
 Make sure that none of the speaker wire strands
have come in contact with an adjoining terminal.
 Repeat steps 1 and 5 to connect speaker wires to
the amplier.
L
R
L
R
A
B
INPUTS
LINE OUT
USB POWER
POWER
OUTPUT
L
OUTPUT
R
Made in China
Intertek
3056826
CONFORMS TO
UL STD 60065
CERTIFIED TO
CSA STD
C22.2 No. 60065
Left SpeakerRight Speaker
Speaker Connections