Owner's Manual
Table Of Contents
Connecting Your System
Step
1-
Speaker Wire Connection
Connect the
RED
(+) and
BLACK
(-)
terminals from the left speaker
to
the
corresponding terminals on the right speaker using the included speaker
wire.
Be
sure
to
match the gold-colored side
of
the speaker wire with the
RED
(+) terminals and the silver-colored side
to
the
BLACK
(-)
terminals on
each speaker.
Note:
As
the
Audioengine 5
speaker
system
is
self-powered,
do
not connect
the
speaker
terminals
to
the
speaker
outputs ofa
stereo
receiver.
Detailed procedure:
• Remove the pre-cut insulation on the end
of
the speaker wire and twist
the exposed wire strands
2-3
times.
•
Use
your
thumb
and finger
to
unscrew the binding post connector.
• Insert each speaker wire into the holes on the side
of
the binding post
connector.
• Retighten the binding posts. The stripped wire portion should be
secured firmly in the connector.
Repeat the procedure
to
connect the other end
of
the speaker wire
to
the
other speaker.
Be
sure
to
match the wire color
to
the same terminal color on
each speaker.
Also,
make sure
that
none
of
the speaker wire strands have
come in contact with
an
adjoining terminal.
Step 2 - Power Cable Connection . _
• Verify that the power switch on the rear panel
is
in the
OFF
position.
• Verify that the voltage selector switch
is
set
to
the proper voltage for
your
area.
• Connect the power cord into the left speaker and the other end into the
wall outlet.