Specifications
Crestron MPS-200 Multimedia Presentation System 200
Hardware Connections for the MPS-200, Rear
TO SPEAKERS:
8-OHM STEREO (MPS-200)
70 VOLT MONO (MPS-200-70V)
100 VOLT MONO (MPS-200-100V)
AUDIO INPUTS:
FROM VIDEO AND
RGB SOURCES
MICROPHONE/LINE INPUT:
FROM MICROPHONE OR
LINE-LEVEL SOURCES
PROGRAM AUDIO OUTPUT:
TO AMPLIFIER OR
AMPLIFIED SPEAKERS
IR/SERIAL OUT:
TO IRP2 IR EMITTER PROBE
or ONE-WAY SERIAL
CONTROLLED DEVICES
IR IN:
FROM
CNXRMIRD IR
RECEIVER
INPUT:
FROM DEVICE OUTPUTS
CONTACT OR RELAY
CLOSURES (24 VOLTS MAX)
RELAY OUTPUT:
TO CONTROLLABLE
DEVICES
COM A & COM B:
BI-DIRECTIONAL RS-232 WITH
HARDWARE & SOFTWARE
HANDSHAKING AND MODEM CONTROL
LAN:
10/100 BASE-T
ETHERNET TO LAN
CRESNET:
TO ANY
CRESNET
DEVICE
POWER:
FROM LINE VOLTAGE
GROUND:
TIE ALL SOURCE AND
DEVICE GROUNDS TO
GROUND TERMINAL
OUTPUT 1:
TO COMPOSITE,
COMPONENT, S-VIDEO,
AND RGB INPUTS OF
DISPLAY DEVICE
RECORD OUTPUT:
TO CODEC, RECORDING
DEVICE, OR ASSISTIVE
LISTENING SYSTEM
SPEECH OUTPUT:
TO AMPLIFIER OR
AMPLIFIED SPEAKERS
INPUTS 1 - 4:
FROM COMPOSITE,
COMPONENT, OR
S-VIDEO SOURCES
INPUTS 5-8:
FROM RGBHV & RGBS
SOURCES
OUTPUT 2:
TOUCHPANEL OUTPUTS TO “QM”
or “CH” TYPE TOUCHPANELS
When running the out-of-the-box program, the MPS-200 can support the following
Crestron devices:
• (2) APAD
• (2) C2N-FTB
• (2) CNX-B12
• (2) C2N-DB12
• (2) CLW-DIM1RF / CLW-DIMS1RF (requires Crestron Toolbox for
implementation)
• (2) CLW-SW1RF / CLW-SWS1RF (requires Crestron Toolbox for
implementation)
• (1) QM-AMP3x80MM/SR
• (1) C2N-MNETGW
• (1) CLS-C6
• (1) RoomView Express or RoomView Server Edition connection
CAUTION: Speakers must be rated to full available output.
CAUTION: Do not bridge speaker outputs
CAUTION: All source devices should be grounded to the MPS-200.
NOTE: The MPS-200 can only be powered by the included power cord. Power
cannot be supplied from network devices that are connected to the mini-terminal
block connectors.
NOTE: For Cresnet, CAT5, and QuickMedia connections, use Crestron Certified
Wire.
NOTE: When running the out-of-the-box program, relays 1 and 2 are momentary.
Operations Guide – DOC. 6528B Multimedia Presentation System 200: MPS-200 • 25