Manual
page 4
Figure 1: Basic Installation Of The Epicenter Plus
Quick Install Information
Integration With A Factory Installed Audio System
We interrupt your reading of this manual to provide the impatient people with
“Quick Install” information and guidelines. No matter how much more of this
manual you read, denitely look at the system drawings on page 10. Not only
will they help with system design, but if you look at them backwards you may
nd a hidden message (NOT!).
As you have probably gured out by now, The Epicenter Plus needs to be
installed in the signal path between a source and an external amplier(s). If your
factory installed audio system has an amplier, then use the speaker wires after
the factory amplier to feed a signal into The Epicenter Plus.
The Epicenter Plus also works the best when it receives a full range signal. If
you feel your bass response is somewhat lackluster, then the frequency response
of the signal you are feeding The Epicenter Plus may be too low. Try nding a
full range signal or use an AudioControl LC6i to sum the signals together.
Once this is done, you just need to hook up power, ground, trigger, run the
wire to the dash remote and tada!!! Instant bass. If you need to know more,
then read on. Heck if you don’t think you need to know more, you should still
read on, because you can never know too much.
We now return you to your normal owner’s manual…