Line Driver / Volume Control HTS Owner's Enjoyment Manual Congratulations! You have just purchased a high-performance auto sound product, the Audio Control OVERDRIVE PLUS Line Driver. The OVERDRIVE PLUS will allow you to utilize every last bit of performance and sound quality that you've always strives for from your vehicle’s sound system. In addition, your new OVERDRIVE PLUS provides you with an input to accept an optional dash mounted remote level control.
Features High-Voltage Line Driver The OVERDRIVE PLUS is a line driver that takes the input voltage of a high performance source unit and increases volts peak). It then delivers this punched up signal to the amplifier for more lifelike sound with less noise, less distortion and more dynamic range. In short: it makes music played on your system sound more like live music.
Remember: At full gain, this unit has enough output to “overdrive”, no pun intended, many amps. The LED read voltage not sound and are only used to warn you of potential clipping issues. If you get plenty of volume without lighting the LED's Don’t Worry! It just means you're not clipping and you have lots of Headroom in the signal. Electable Ground Isolation Avoiding ground loops and grounding-related noises are of paramount importance in any installation.
A Guided Tour of the OVERDRIVE PLUS The Outside 1) Inputs: The Audio Control OVERDRIVE PLUS inputs get their signals directly from the main source unit/head unit. Audio Control's high impedance input design means you get less noise and fewer ground loops. 2) Input Gain Control: Used to increase the amount of signal to your downstream signal processors or amplifiers. With this control you can get up to 24dB of gain or 13 volts peak (9.5 volts RMS) to your signal processor or amplifier inputs.
Audio Control’ Mount lake Terrace, WA 98043 USA 425-775-8461 uncontrollably com @© © Power Volt input Gain ® @\ 1 Volt ped High Gain Pr-amp Line Driver PLUS 24db Gain, Remote Level Control Input Inputs Outputs Remote Remote Ground . . EVE Left Right Left Right Control +12 Cc CTT C770 Volt: This light will tell you when the signal level is at 1 volt. Most head units will give you enough juice to light this one.
7) Power Connector: This convenient little connector allows you to hook up all the power and turn-on wires for your OVERDRIVE PLUS Line Driver in the convenience of a well-lighted area and then plug them in by feel all at once in your tank's cavernous darkness. Screws on top of the connector should face up.
grounding choices. Experiment with different settings if you run into this problem. To change the settings, turn system power OFF, move the black jumper from the center two pins (fully isolated) to either the top two pins (ground) or the bottom two pins (2000). Short course in Signal-to-Noise Ratio and Level Matching Signal-to-noise ratio is the difference between the signal level and the noise floor of an electronic component. The higher the signal, the better.
VERT IS HVS Specifications All specifications are measured at 14.4 VDC (standard automotive voltage) As technology advances, Audio Control reserves the right to continuously change our specifications, like our weather. Maximum input/output level oir, peak Optional Dash Re Mote +0dB / -90dB Frequency cr Total harmonic distortion. .ev veronica 0.005% Signal to NOISE AHOY. eerie sneer >110dB Input Impedance... 20 Ohms Output IMPedance...c...
