User`s manual

MP-1xx H.323
MP-1xx H.323 User’s Manual 98 Document #: LTRT-65104
5.8.9 Configuring the Hunt Group Settings Table
The Hunt Group Settings is used to determine the method in which new calls are assigned to
channels within each hunt group. If such a rule doesn’t exist (for a specific hunt group), the global
rule, defined by the ‘Channel Select Mode’ parameter (Protocol Definition > General Parameters),
applies.
 To configure the Hunt Group Settings table, take these 7 steps:
1. Open the ‘Hunt Group Settings’ screen (Protocol Management menu > Hunt Group
Settings); the ‘Hunt Group Settings’ screen is displayed.
Figure
5-26: Hunt Group Settings Screen
2. In the ‘Routing Index’ drop-down list, select the range of entries that you want to edit (up to
24 entries can be configured).
3. In the ‘Hunt Group ID’ field, enter the hunt group ID number.
4. In the ‘Channel Select Mode’ drop-down list, select the Channel Select Mode that
determines the method in which new calls are assigned to channels within the hunt groups
entered in the field to the right of this field. For information on available Channel Select
Modes refer to Table
5-26.
5. Repeat steps 3 and 4, for each defined hunt group.
6. Click the Submit button to save your changes.
7. To save the changes so they are available after a power fail refer to Section
5.12 on page
140.