User`s manual

MP-1xx H.323
MP-1xx H.323 User’s Manual 92 Document #: LTRT-65104
5.8.8 Configuring the Endpoint Settings
The Endpoint Settings screens enable you to configure port-specific parameters.
5.8.8.1 H.323 Port ID
The H.323 Port ID table enables you to assign a specific ID to each port. These IDs are used for
registration to the Gatekeeper (RRQ) when ‘GWRegistrType’ = 1 or 2 and for Gatekeeper
admission (ARQ) and call initialization when ‘SourceEncodeType’ = 1 or 2. This table is ignored if
the parameter ‘H323IDString’ is configured. For detailed information on gateway registration with
a Gatekeeper refer to Section
8.2 on page 152.
Note: In the current release IPTel routing according to H.323 port ID isn’t supported.
 To configure the H.323 port ID table, take these 5 steps:
1. Open the ‘H.323 Port ID’ screen (Protocol Management menu > Endpoint Settings
submenu > H.323 Port ID option); the ‘H.323 Port ID’ screen is displayed.
Figure
5-21: H.323 Port ID Screen
2. In the ‘H.323 Port ID’ field, enter the H.323 ID string that is assigned to the gateway’s port in
the field to the left of this field. You can enter a string up to 20 characters long.
3. Repeat step 2 for each gateway port.
4. Click the Submit button to save your changes.
5. To save the changes so they are available after a power fail refer to Section
5.12 on page
140.
Table
5-21: H.323 Port ID ini File Parameter
Parameter Name in ini File Parameter Format
PortName_x
PortName_<port> = <H.323 Port ID string>
For example:
PortName_0 = Port ID 1
Note 1: The numbering of channels starts with 0.
Note 2: This parameter can appear up to eight times for MP-108, and up
to 24 times for MP-124.