User`s manual

MP-1xx H.323 User’s Manual 5. Configuring the MP-1xx
Version 4.4 91 March 2005
Table 5-20: Endpoint Phone Numbers Table
Parameter Description
Hunt Group ID In each of the Hunt Group ID fields, enter the hunt group ID (1-99) assigned to the
channel(s). The same hunt group ID can be used for more than one channel and in
more than one field.
The hunt group ID is an optional field that is used to define a group of common
behavior channels that are used for routing IP to Tel calls. If an IP to Tel call is
assigned to a hunt group, the call is routed to the channel or channels that correspond
to the hunt group ID.
You can configure the Hunt Group Settings table to determine the method in which
new calls are assigned to channels within the hunt groups (refer to Section
5.8.8.5 on
page 97).
Note: If you enter a hunt group ID, you must configure the IP to Hunt Group Routing
Table (assigns incoming IP calls to the appropriate hunt group). If you do not configure
the IP to Hunt Group Routing Table, calls don’t complete.
For information on how to configure the IP to Hunt Group Routing Table refer to
Section
5.8.4.3 on page 77.
Profile ID Enter the number of the Tel profile that is assigned to the endpoints defined in the
‘Channel(s)’ field.
Parameter Name in ini File Parameter Format
TrunkGroup_x
TrunkGroup_<Hunt Group ID> = <Starting channel> - <Ending channel>, <Phone
Number>, <Tel Profile ID>
For example:
TrunkGroup_1 = 1-4,100
TrunkGroup_2 = 5-8,200,1
Note 1: The numbering of channels starts with 1.
Note 2: ‘Hunt Group ID’ can be set to any number in the range 1 to 99.
Note 3: When ‘x’ (Hunt Group ID) is omitted, the functionality of the TrunkGroup
parameter is similar to the functionality of ChannelList and Channel2Phone
parameters.
Note 4: This parameter can appear up to 8 times for MP-108 Gateways and up to 24
times for MP-124 Gateways.
Note 5: An optional Tel ProfileID (1 to 5) can be applied to each group of channels.
ChannelList
Note: TrunkGroup_x parameter
can be used instead.
List of phone numbers for MP-1xx channels
a, b, c, d
a = first channel.
b = number of channels starting from “a”.
c = the phone number of the first channel.
d = Tel Profile ID assigned to the group of channels.
For example: ChannelList = 0,8,101, defines phone numbers 101 to 108 for up to 8
MP-108 channels.
Note 1: The ini file can include up to 24 “ChannelList = “ entries.
Note 2: The “ChannelList“ can be used instead of, or in addition to, Channel2Phone
parameter.
Channel2Phone
Phone number of channel.
Its format: Channel2Phone = “<channel>, <number>”
<channel> is 0...23.
Example: “Channel2Phone = 0, 1002”
Appears once for each channel: 8 times for MP-108, or 4 times for MP-104 and twice
for MP-102.
For 8-port and 24-port gateways it is suggested to use “TrunkGroup“ parameter,
where in a single line, all gateway’s phone numbers can be defined.
Note: When ‘Channel2Phone’ is used to define an endpoint, hunt group and profile
can’t be assigned to that endpoint.