User`s manual

MP-1xx H.323
MP-1xx H.323 User’s Manual 88 Document #: LTRT-65104
5.8.6 Configuring the Registration Prefixes
The Gatekeeper Registration Prefixes Table enables the MP-1xx to register with a Gatekeeper by
associating dialing plan information with specific digit prefixes.
The Gatekeeper Registration Prefixes Table data is sent when the gateway requests permission
to register with the Gatekeeper. This registration request is triggered by a gateway reset, or by
the user from the Web Interface.
The prefix registration encoding type is configured by the parameter ‘Gateway Registration Type’
(described in Table
5-2). If ‘Gateway Registration Type’ parameter contains NPI/TON
(GwRegistrType = 3 or 4) the gateway uses the prefixes defined in the ‘Registration Prefixes’
table to register as ‘PartyNumber’. In this registration mode the “Type of Number” columns are
used, to define the prefix’s TON. In other modes (GwRegistrType = 0, 1 or 2), the TON column is
ignored.
For detailed information on the available methods the MP-1xx gateway registers with a
Gatekeeper refer to Section
8.2 on page 152.
 To configure the Registration Prefixes, take these 4 steps:
1. Open the ‘Registration Prefixes Table’ screen (Protocol Management menu > Registration
Prefixes); the ‘Registration Prefixes Table’ screen is displayed.
Figure
5-19: Registration Prefixes Table Screen
2. Configure the Registration Prefixes according to Table
5-19.
3. Click the Submit button to save your changes or click the Re-Register button to save your
changes and to re-register to the Gatekeeper.
4. To save the changes so they are available after a power fail refer to Section
5.12 on page
140.