User`s manual

MP-1xx H.323 User’s Manual 5. Configuring the MP-1xx

Version 4.4 85 March 2005

the coders is performed (i.e., only common coders remain). The order of the coders is

determined by the preference.

5. Configure the Profile’s parameters according to your requirements. For detailed information

on each parameter refer to the description of the screen in which it is configured as an

individual parameter.

6. In the ‘Coder Group’ drop-down list, select the coder group you want to assign to that Profile.

You can select the gateway’s default coders (refer to Section

5.8.1.3 on page 52) or one of

the coder groups you defined in the Coder Group Settings screen (refer to Section

5.8.5.1 on

page 82).

7. Repeat steps 2 to 6 for the second to fifth Tel Profiles (optional).

8. Click the Submit button to save your changes.

9. To save the changes so they are available after a power fail refer to Section

5.12 on page

140.

Table

5-17: ini File Tel Profile Settings

Parameter Description

TelProfile_ID

TelProfile_<Profile ID> =

<Profile Name>,<Preference>,<Coder Group ID>,<IsFaxUsed *>,<DJBufMinDelay *>,

<DJBufOptFactor *>,<IPDiffServ *>,<ControlIPDiffServ*>,<DtmfVolume>,<InputGain>,

<VoiceVolume>,<EnableReversePolarity>,<EnableCurrentDisconnect>,

For example:

TelProfile_1 = FaxProfile,1,2,0,10,5,22,33,2,22,34,1,0,1,1

TelProfile_2 = ModemProfile,0,10,13,$$,$$,$$,$$,$$,0,$$,0,0,1,1

$$ = Not configured, the default value of the parameter is used.

(*) = Common parameter used in both IP and Tel profiles.

Note: This parameter can appear up to 4 times.