User`s manual

MP-1xx H.323
MP-1xx H.323 User’s Manual 64 Document #: LTRT-65104
Table 5-6: Supplementary Services Parameters (continues on pages 21 to 64)
Parameter Description
Waiting Beep Duration
[WaitingBeepDuration]
Duration (in msec) of waiting indications that are played to the receiving side of the call
(FXS only) for Call Waiting.
The default value is 300.
Enable Caller ID
[EnableCallerID]
Disable [0] = Disable the Caller ID service (default).
Enable [1] = Enable the Caller ID service.
If the Caller ID service is enabled, then for FXS gateways, calling number and Display
text are sent to gateway port.
For FXO gateways, the Caller ID signal is detected and is sent to IP in H.323 Setup
message (as Calling number and "Display" text).
For information on the Caller ID table refer to Section
5.8.8.3 on page 94.
To disable/enable caller I generation per port, refer to Section 5.8.8.5 on page 97.
Caller ID Type
[CallerIDType]
Defines one of the following standards for detection (FXO) and generation (FXS) of
Caller ID signals.
Bellcore [0] (default).
ETSI [1].
NTT [2].
British [4]
DTMF ETSI [16]
Denmark [17]
India [18]
Brazil [19]
Note: The Caller ID signals are generated/detected between the first and the second
rings.
Message Waiting Indication (MWI) Parameters
Enable MWI
[EnableMWI]
Disable [0] = Disabled (default).
Enable [1] = H.450.7 MWI service is enabled.
This parameter is applicable only to FXS gateways.
Note: The MP-1xx only supports reception of MWI.
MWI Analog Lamp
[MWIAnalogLamp]
Disable [0] = Disable (default).
Enable [1] = Enable visual Message Waiting Indication, supplies line voltage of
approximately 100 VDC to activate the glow lamp (on a phone that is equipped with an
MWI lamp).
This parameter is applicable only to FXS gateways.
MWI Display
[MWIDisplay]
Disable [0] = Disabled (default).
Enable [1] = Enable digital MWI using Caller ID Interface.
If enabled, the gateway generates an MWI FSK message that is displayed on the MWI
display.
This parameter is applicable only to FXS gateways.
Stutter Tone Duration
[StutterToneDuration]
Duration (in msec) of the played stutter dial tone that indicates waiting message(s).
The default is 2000 (2 seconds). The range is 1000 to 60000.
The Stutter tone is played (instead of a regular Dial tone) when a MWI is received. The
tone is composed of a ‘Confirmation tone’ that is played for ‘StutterToneDuration’
followed by a ‘Stutter tone’. Both tones are defined in the CPT file.
Note: This parameter is applicable only to FXS gateways.
For detailed information on Message Waiting Indication (MWI), refer to Section xxx on
page xxx.