User`s manual

MP-1xx H.323 User’s Manual F. Accessory Programs and Tools
Version 4.4 223 March 2005
4. In the Invalid phone number field, enter a number that generates a “fast busy” tone when
dialed. Usually, any incorrect phone number should cause a “fast busy” tone.
5. Press Next.
Note: The CPTWizard communicates with the MP-10x/FXO gateway via TPNCP
(TrunkPack Network Control Protocol). If this protocol has been disabled in
the gateway configuration, the CPTWizard doesn’t display the next screen
and an error is reported.
F.2.4 Recording Screen – Automatic Mode
After the connection to the MP-1xx/FXO gateway is established, the recording screen is
displayed.
Figure F-7: Recording Screen –Automatic Mode
 To start recording in automatic mode:
Press the Start Automatic Configuration button; the wizard starts the following Call Progress
Tones detection sequence (the operation takes approximately 60 seconds to complete):
1. Sets port 1 offhook, listens to the dial tone
2. Sets port 1 and port 2 offhook, dials the number of port 2, listens to the busy tone
3. Sets port 1 offhook, dials the number of port 2, listens to the Ringback tone
4. Sets port 1 offhook, dials an invalid number, listens to the reorder tone
5. The wizard then analyzes the recorded Call Progress Tones and displays a message
specifying the tones that were detected (by the gateway) and analyzed (by the wizard)
correctly. At the end of a successful detection operation, the detected Call Progress Tones
are displayed in the Tones Analyzed pane (refer to Figure F-8).