User`s manual

MP-1xx H.323
MP-1xx H.323 User’s Manual 162 Document #: LTRT-65104
8.10.2 Using Two Gateways with Gatekeeper
In this demo, a call can be made from an endpoint in one gateway to an endpoint in another.
 To configure the ini file parameters, take these 8 steps:
1. Use Gatekeeper.
2. In “GatekeeperIP”, insert the IP of the PC that runs the Gatekeeper.
3. Endpoint numbers of the first MP-108 gateway: 101...108.
4. Endpoint numbers of the second MP-108 gateway: 201...208.
5. Run Gatekeeper on the PC.
6. Start MP-108 gateways and load the configuration ini file.
7. Make a call from one endpoint to the other.
8. Display the Gatekeeper log messages to show the Gatekeeper activities.
8.10.3 Using Gateway with NetMeeting™
In this demo, a call can be made from an endpoint in one gateway to NetMeeting™.
 To configure ini file parameters, take these 7 steps:
1. Configure endpoint numbers of the MP-108/FXS gateway: 101...108.
2. Configure NetMeeting IP address using prefix definition:
Prefix = ’200, NetMeeting IP address’.
3. Start MP-108 gateway and load the configuration ini file.
4. Set default number for NetMeeting to MP-108 calls: DefaultNumber =101 (or any other
number 102 to 108).
5. Start MP-108 gateway and load the configuration ini file.
6. Make a call from any MP-108 endpoint to NetMeeting™ by dialing 200.
7. Make a call from NetMeeting™ to IP address of MP-108. The phone connected to port 1 of
the MP-108 then rings.
8.10.4 Remote IP Extension between FXO and FXS
This application explains how to implement remote extension via IP, using MP-108/FXO and MP-
108/FXS gateways. In this configuration, PBX incoming calls are routed to the “Remote
Extension” via the MP-108/FXO and MP-108/FXS gateways.
Requirements:
• One MP-108/FXO gateway
• One MP-108/FXS gateway
• Analog phones (POTS)
• PBX – one or more PBX loop start lines
• LAN
Connect the MP-108/FXO ports directly to the PBX lines as shown on the diagram below: