User`s manual

MP-1xx H.323
MP-1xx H.323 User’s Manual 152 Document #: LTRT-65104
8.2 MP-1xx Registration with a Gatekeeper
The MP-1xx supports three different methods of registration with a Gatekeeper:
8.2.1 Registration with Prefixes
The gateway registers with a Gatekeeper using prefixes (range of numbers).
To register with prefixes:
1. Configure the Registration Prefixes Table (refer to Section
5.8.6 on page 88).
2. Set the GWRegistrType parameter (Table
5-2) according to your requirements:
 E.164 [0] = The gateway registers the prefixes using E.164 format (default).
 H323-ID [1] = The gateway registers the prefixes using H.323-ID format (prefixes are
represented as strings). In this mode don’t configure the H323IDString parameter (if you
do, the gateway only registers with H323IDString and the prefixes are ignored).
 E.164 and H323-ID [2] = The gateway registers the prefixes using E.164 and H.323-ID
formats. In this mode the H323IDString (if defined) is added once to the Registration
Request; if not defined, each prefix registers twice, in E.164 format and H.323-ID format
(as a string).
 NPI/TON from Table [3] = The gateway registers the prefixes using Type of Number
format (refer to the note below).
 NPI/TON and H323-ID [4] = The gateway registers the prefixes using Type of Number
and H323-ID formats (refer to the note below). The H323-ID functionality is identical to
the functionality explained in option [2].
Note: If ‘GWRegistrType’ parameter contains NPI/TON (options [3] or [4]) the gateway uses
the prefixes defined in the ‘Registration Prefixes Table to register as ‘PartyNumber’. In this
registration mode the “Type of Number” columns are used, to define the prefix’s TON. In
other modes (options [0], [1] or [2]), the TON column is ignored.
8.2.2 Registration with H.323-ID
The gateway registers with a Gatekeeper using a single descriptive name.
To register with H.323-ID:
1. Set the Gateway Registration Type parameter to H.323-ID (GwRegistrType = 1).
2. Configure the H.323-ID (H323IDString) parameter.
8.2.3 Registration with Endpoints
The gateway registers with the Gatekeeper using the numbers defined in the ‘Endpoint Phone
Numbers’ Table (normally used with FXS gateways).
To register with endpoints:
1. Don’t configure the Registration Prefixes Table.
2. Set the GWRegistrType parameter according to your requirements:
 E.164 [0] = The gateway registers the endpoints using E.164 format.
 H323-ID [1] = The gateway registers the endpoints with the port IDs specified in the
‘H.323 Port ID’ table (if the ‘H.323 Port ID’ table isn’t configured, the endpoints are
represented as strings). In this mode don’t configure the H323IDString parameter (if you
do, the gateway only registers with H323IDString and the H.323 Port IDs / endpoints are
ignored).
 E.164 and H323-ID [2] = The gateway registers the endpoints using E.164 and H.323-ID
formats. In this mode the H323IDString (if defined) is added to the Registration Request