User`s manual

MediaPack
SIP User's Manual 98 Document #: LTRT-65408
5.5.5 Configuring the Routing Tables
Use this submenu to configure the gateway’s IPÆTel and TelÆIP routing tables and their
associated parameters.
5.5.5.1 General Parameters
Use this screen to configure the gateway’s IPÆTel and TelÆIP routing parameters.
¾
To configure the general parameters under Routing Tables, take
these 4 steps:
1. Open the ‘General Parameters’ screen (Protocol Management menu > Routing
Tables submenu > General option); the ‘General Parameters’ screen is displayed.
Figure 5-16: Routing Tables, General Parameters Screen
2. Configure the general parameters under ‘Routing Tables’ according to Table 5-16.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section 5.10.2 on
page 205.
Table 5-16: Routing Tables, General Parameters (continues on pages 98 to 99)
Parameter Description
Add Hunt Group ID as
Prefix
[AddTrunkGroupAsPrefix]
No
[0] = Don’t add hunt group ID as prefix (default).
Yes
[1] = Add hunt group ID as prefix to called number.
If enabled, then the hunt group ID is added as a prefix to the destination phone
number for TelÆIP calls.
Note 1: This option can be used to define various routing rules.
Note 2: To use this feature you must configure the hunt group IDs.
Add Port Number as Prefix
[AddPortAsPrefix]
No
[0] = Disable the add port as prefix service (default).
Yes
[1] = Enable the add port as prefix service.
If enabled, then the gateway’s port number (single digit in the range 1 to 8 for 8-
port gateways, two digits in the range 01 to 24 in MP-124) is added as a prefix to
the destination phone number for TelÆIP calls.
Note: This option can be used to define various routing rules.